DESKTOP-N2PA-RCFORB

Rigblaster conneced via USB Com port 4, WMR Radio Control 5, WMR PTT Control 6.
Rigblaster TX sw in Com.
xmit 1/2, RCV level 1/2, Vox delat 1/10 
Rigblaster is using Yaesu 8-pin round Metal - Isolated Jumber.
Connector in rear to Mic jack on MP1000
Jumper from spkr out to AF Out
RS-232 cable from RB advantact to Cat on Radio.
USB from RB to Computer.

HRD Settings
	RS-232 FT-1000MP Com5 4800B no DTR No RTS
	Radio Options - Com port TX - RTS/DTR/Both/None - Com port Pin (RTS)
							 - check always use RTS instead of sending CAT Commands

RCForb Server Settings
	Remote type - Full Remote Radio (Cat Controllable)
	Options - Radio Configuration - via Ham Radio Deluxe
					localhost 7809
		PTT&CW keying		PTT(TX) via COM, CW Key  disabled, external PTT Com port 6, on TX use RTS checked.
	Audio Settings - Microphone RX audio from Radio (Microphone (2-RigBlaster Advan) Waveout
	Audio Settings - Speakers  TX audio to Radio Speakers (2-RigBlaster Advan) speex 

RCForb Client
spkr (logitech headset)
Mic (Logitech headset)
VOL and Mic 3/4 full

Account is K2MTH password is wildfire